Preform Injection Molding Machine For 48 Cavities Preform Mould

Demark 32 cavities pet preform injection system uses a new part cooling and handling system, which features:
1. Cooling on the inner surface of the preform without using compressed air, unlike most post-mold cooling systems which only cool the outer surface
2. Optimized cycle utilization ?being mounted on the moving platen, the cooling system remains active for up to 85% of the overall cycle.

Demark pet preform injection systems are available from 28 to 50 tonnes (280 to 500 kN) and up to 72 cavities.
Demark pet injection systems offer:
1.Faster cycles
2.Reduced energy consumption
3.Smaller footprint
4. Improved repeatability
5. Rapid set-up
1. Two state plasticizing enables plenty injection quantity;
2. Take out plate with three working position insures sufficient cooling time and shorter cycle time;
3. High quality parts and accessories from world famous brands enable higher speed and precision;
4. Special screw design increases torque while brings down shear force to avoid degradation;
5. Accumulator from world reputable manufacture increases performance while brings down power consumption;

Reflex Platens
Reflex platens distribute clamp force evenly across the platen face.
Reflex platens:
1. Allow for 10-30% lower clamp tonnage
2. Decrease mold wear
3. Improve part quality

Injection Units
demark systems offer both reciprocating screw (RS) and two-stage injection units. RS units offer the performance required for many PET applications while two-stage is appropriate for higher throughput applications.

Polaris Controls
PC-based controls manage all functions of our PET production systems, with optional packages to integrate auxiliaries and downstream part handling equipment. Advantages include:
1. Faster cycle times
2. Improved shot-to-shot repeatability
3. Remote connectivity through ServiceNetLink
4. Control of molding system and auxiliaries from a single interface

Linear Bearings
Linear bearings support the moving platen directly on the machine base. This design reduces mold wear by improving platen alignment and perpendicularity, and provides a grease free molding environment.